RetroCompass
RetroCompass

8BitDo Zero 2 — Reset

Quick answer

Button combo

power off(START 8s)re-pair

Steps

  1. 1Force the controller off: hold START for 8 seconds.
  2. 2Power back on in the correct mode (e.g. START + X).
  3. 3Hold SELECT until the blue LED blinks fast to re-enter pairing.
  4. 4Remove the old 8BitDo Zero 2 entry from your device, then pair again.

LED states

  • off—Powered off
  • fast blink—Pairing after reset
Last verified: 2026-06-20Source: support.8bitdo.com

The Zero 2 has no dedicated reset combo; if it gets stuck, force it off by holding START for 8 seconds, then power back on in the right mode and re-pair with SELECT. It also helps to delete the old Zero 2 entry in your phone or PC Bluetooth list before pairing fresh. For firmware-level issues, use the 8BitDo Firmware Updater.

FAQ

Is there a factory reset?
No single combo — force-off with START (8s) and re-pair clears connection issues.
It still won't behave — now what?
Run the 8BitDo Firmware Updater over USB to reflash the firmware.

Same device — other tasks

Other devices — same task