RetroCompass
RetroCompass

GuliKit KingKong Pro — Reset

Quick answer

Button combo

Mode(double-click off)Mode(one click on)

Steps

  1. 1Double-click the Mode button to shut the GuliKit KingKong Pro fully off.
  2. 2Wait a few seconds, then press the Mode button once to power it back on.
  3. 3If a host link is stuck, set the correct mode (hold Mode ~2s) and re-pair with the pairing button.
  4. 4If inputs feel off, leave it idle 10 minutes so it auto-sleeps, then power on fresh.
  5. 5Still misbehaving? Charge it via USB-C and re-pair before reaching out to support.

LED states

  • all off—Powered down after a double-click
  • scrolling—Back on and ready to pair again
Last verified: 2026-06-20Source: fcc.report

The original KingKong Pro has no dedicated factory-reset pinhole or button combo, unlike later KingKong models. The everyday fix is a clean power-cycle: double-click Mode to shut down, then single-click Mode to restart. This clears most connection glitches. If a stored Bluetooth link refuses to reconnect, reselect the right mode by holding Mode ~2 seconds and pair again from scratch. Charging over USB-C also helps rule out a low-battery cause.

FAQ

Is there a reset hole on the back?
No. The original KingKong Pro has no reset pinhole; that is a later-model feature. Power-cycle with the Mode button instead.
How do I clear a bad pairing?
Power-cycle, hold Mode ~2s to set the correct mode, then hold the pairing button ~2s and pair fresh.

Same device — other tasks

Other devices — same task