RetroCompass
RetroCompass

Flydigi Apex 4 — Firmware update

Quick answer

Steps

  1. 1Install Flydigi Space Station on your PC (or Flydigi Game Center on mobile).
  2. 2Connect the Apex 4 by USB-C (recommended) or the 2.4G dongle — not Bluetooth.
  3. 3Let the app detect it; if an update is offered, start it and keep the cable connected.
  4. 4Wait for completion; Flydigi Space Station also enables adaptive triggers and stick calibration.

LED states

  • slow flash—Firmware updating — do not disconnect (indicative)
Last verified: 2026-06-20Source: shops.flydigi.com

Update the Apex 4 with Flydigi Space Station on PC (or Flydigi Game Center on mobile). Connect by USB-C or the 2.4G dongle so the app can detect it — Bluetooth doesn't expose firmware/settings. The tool prompts when controller or dongle firmware is available; keep it connected until done. Flydigi Space Station is also where you enable adaptive triggers, tune sticks and run calibration.

FAQ

Where do I enable the adaptive triggers?
In Flydigi Space Station (connected by USB-C or 2.4G dongle) — it also handles firmware and calibration.
Calibration tip?
With the controller connected, hold the calibration combo / use the guided calibration in Flydigi Space Station; keep sticks centered when prompted.

Same device — other tasks

Other devices — same task